Mercury 45 Jet 50-55 - Power Trim System Removal

90-817643R1 DECEMBER 1996 MID-SECTION - 5B-21
Power Trim System Removal
Support outboard with tilt lock lever when servicing
power trim system.
1. Disconnect power trim harness from outboard
wiring harness.
2. Remove screw and clip securing wiring harness
to clamp bracket.
3. Use suitable tool to remove (DRIVE DOWN) up-
per dowel pin. Retain dowel pin.
51144
a
a - Dowel Pin
4. Use suitable punch to drive out upper pivot pin.
51144
a
a - Pivot Pin
5. Use suitable punch to remove (DRIVE UP) lower
dowel pin. Retain dowel pin.
51144
a
a - Dowel Pin
6. Use suitable punch to drive out lower pivot pin.
51144
a
a - Pivot Pin