MID-SECTION - 5C-3390-817643R1 DECEMBER 1996
Reservoir Installation
1. Connect trim motor wires to harness.
2. Insert motor into reservoir. Motor must be seated
properly prior to end cap installation.
51196
3. Install end cap, O-ring and foam pad to cylinder.
4. Torque screws to 13 lb. in. (1.5 N·m).
51195
a
b
c
a - End Cap
b - O-ring
c - Foam Pad
5. Install grommet, washer and screw cap to cylin-
der end cap. Tighten screw securely.
51195
a
b
c
a - Screw Cap
b - Washer
c - Grommet
6. Place drive shaft into oil pump.
7. Install lubricated O-ring to base of reservoir.
8. Carefully guide (cylinder/motor) down onto drive
shaft.
51194
a
b
a - Drive Shaft
b - O-ring
To Next Page
Loading...
