5C-32 - MID-SECTION 90-8i7643R1 DECEMBER 1996
2. Guide armature and end frame into housing as
shown.
51196
3. Align scribe mark on housing to mark on end
frame.
4. Install lubricated O-ring to end frame.
51194
a
b
a - O-ring
b - Scribe Mark
5. Install washers to armature shaft as shown.
6. Install end cap to housing. Torque nuts to 25 lb. in.
(2.8 N·m).
51194
a
b
c
d
a - End Cap
b - Motor Housing
c - Wave Washer
d - Washer
IMPORTANT: When installing motor, wires (black,
orange) must rest in cavity of cylinder allowing
motor to seat properly.
51194
a
b
a - Manifold
b - Cavity
To Next Page
Loading...
