7A-18 - OUTBOARD INSTALLATION/ATTACHMENTS 90-817643R1 DECEMBER 1996
Route remote control harness or key switch harness (d)
along side oil tank (e) and out of bottom cowl thru opening
(f) in battery cable grommet.
50566
e
d
f
!
CAUTION
Remote control wiring harness and key switch wiring
harness must be routed between control cable rubber
grommet and engine harness connector, so that har-
ness will not interfere with engine throttle and shift op-
eration.
Power Trim Wiring Connections
(Models So Equipped)
Make bullet connector wiring connection, between remote
control wiring harness/key switch wiring harness and en-
gine wiring.
IMPORTANT: Tape back and isolate any unused wiring
harness leads.
a
b
a - Lead From Trim Solenoid (Down Solenoid)
b - Lead From Trim Solenoid (Up Solenoid)
Battery Connections
!
CAUTION
Failure to observe correct polarity when connecting
battery cables to battery will result in damage to the
charging system.
1. Connect battery cables (from engine) to battery. Con-
nect red battery cable to positive (+) battery terminal
and black battery cable to negative (-) battery terminal.
To Next Page
Loading...
