6A-16 - LOWER UNIT 90-817643R1 DECEMBER 1996
Installation Note: If service tools are not available, the fol-
lowing reference dimensions apply for installing bearing
and seals to proper depths.
51275
.82 in. (20mm)
a
a - Bearing
51275
.04 in. (1mm)
.44 in. (11mm)
a
b
a - Oil Seal (Install with Lip Down)
b - Oil Seal (Install with Lip Up)
5. Lubricate O-ring with Special Lubricant 101. Install O-
ring (a).
51263
a
Reverse Gear
1. Lubricate I.D. of bearing (a) with Quicksilver Needle
Bearing Assembly Lubricant. Use Installer Tool and
press onto gear until bearing bottoms.
51205
a
b
a - Bearing
b - Installer Tool (91-817007)
2. Install reverse gear and bearing assembly (a). Lubri-
cate O.D. of bearing with Quicksilver Needle Bearing
Assembly Lubricant before installation.
51264
a
b
c
a - Reverse Gear and Bearing Assembly
b - Installer Tool (91-817007)
c - Bearing Carrier
To Next Page
Loading...
