6A-14 - LOWER UNIT 90-817643R1 DECEMBER 1996
5. Install shift shaft assembly (a); insert splines into shift
cam.
51268
a
Propeller Shaft
1. Install components.
51265
2-4-C Quicksilver Marine LubricantA
a
c
A
b
d
a - Spring
b - Clutch (Align Hole with Slot in Propshaft; Long End of Clutch with 3
Teeth Towards Propshaft Shoulder)
c - Guide Block
d - Cam Follower (Hold in Place with Quicksilver 2-4-C Marine
Lubricant
2. Install cross pin.
a
b
c
51268
a - Cross Pin
b - Cam Follower
c - Apply Pressure in This Direction
3. Install spring.
NOTE: Spring windings must lay flat with no overlapping in
clutch groove after installation.
51265
a
a - Spring
To Next Page
Loading...
