5F-32 - MID-SECTION 90-817643R1 DECEMBER 1996
Shock Rod Installation
1. Place cylinder/manifold assembly into soft jawed
vise.
2. Fill cylinder to top using Quicksilver Power Trim
and Steering Fluid or; (ATF) Type F, FA of Dexron
II.
3. Place cam shaft lever in the open position (lever
facing down).
4. Install lubricated O-ring to memory piston and in-
stall piston into cylinder three inches (76mm) from
top.
51144
b
a
a - O-ring
b - Memory Piston
5. Refill cylinder to top and install shock rod assem-
bly into cylinder.
51143
6. Refill cylinder to top.
CAUTION
End cap must not make contact with shock rod
piston when tightening. Shock rod piston must
be positioned in cylinder deep enough to avoid
contact.
7. Tighten end cap securely using spanner wrench
[1/4 in. x 5/16 in. (6.4mm x 8mm) long pegs].
51145
To Next Page
Loading...
