MID-SECTION - 5F-3190-817643R1 DECEMBER 1996
3. Install lubricated O-ring.
51199
a
b
a - O-ring
b - Shock Piston
4. Clamp shock rod in soft jawed vise.
5. Position cylinder end cap onto rod as shown.
51146
CAUTION
When installing shock rod piston, spanner
wrench must have1/4 in. x 5/16 in. (6.4mm x8mm)
long pegs to avoid damage to shock rod piston.
6. Apply Loctite 271 to threads on shock rod.
7. Install shock rod piston.
8. Tighten shock rod piston securely using spanner
wrench (1/4 in. x 5/16 in. long pegs).
51146
b
a
a - Shock Rod Piston
b - Spanner Wrench
9. Remove shock rod assembly from vise.
10. Install lubricated O-ring to shock rod piston.
11. Install ball, seat, and spring (five sets) to shock
rod piston.
12. Secure components with plate. Torque screws to
35 lb. in. (4.0 N·m).
51147
b
c
d
e
f
a
a - Screw (3)
b - Plate
c - O-ring
d - Ball (5)
e - Seat (5)
f - Spring (5)
To Next Page
Loading...
