5C-38 - MID-SECTION 90-8i7643R1 DECEMBER 1996
6. Apply Special Lubricant 101 (92-13872A1) to sur-
face of upper pivot pin, pivot pin bore and trim ram
bore.
b
c
a
51148
a - Pivot Pin
b - Pivot Pin Bore
c - Trim Ram Bore
7. Using a suitable mallet, drive upper pivot pin into
swivel bracket and through trim ram until pivot pin
is flushed with swivel bracket.
b
c
a
51148
a - Pivot Pin
b - Swivel Bracket
c - Trim Ram
8. Drive upper dowel pin (a) into its hole until seated.
a
51147
9. Recheck fluid level.
10. Power trim may now be operated to lower out-
board to desired position. Trim system is self
bleeding.
11. Re-connect spark plug leads to spark plugs.
12. Re-install top cowl.
13. Connect battery leads to battery terminals.
To Next Page
Loading...
