POWERHEAD - 4-2790-817643R1 DECEMBER 1996
2. Install needle bearings.
PE-51081
a
b
a - Needle Bearings (29)
b - Sleeve [from Piston Pin Tool (91-74607A2)]
3. Place locating rings on connecting rod, carefully place
piston over end of rod. Refer to scribed identification
number for matching rod to piston and direction of as-
sembly (which side of rod is “UP”).
PE-51083
1
1
a
b
a - Scribed Identification Number
b - Locating Washer
4. Push sleeve from piston using piston pin tool.
PE-51080
a
b
a - Sleeve
b - Piston Pin Tool (91-74607A2)
5. Place piston pin over tool, and tap into position (driving
tool out other side).
PE-51086
a
b
a - Piston Pin
b - Piston Pin Tool
! WARNING
Eye protection must be worn while installing piston
pin lockrings.
To Next Page
Loading...
