5B-38 - MID-SECTION 90-817643R1 DECEMBER 1996
4. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
51147
a
a - Lower Pivot Pin
5. Using a suitable punch, drive lower dowel pin into
its respective bore until seated.
51148
a
a - Lower Dowel Pin
6. Apply 2-4-C Marine Lubricant (92-90018A12) to
surface of upper pivot pin, pivot pin bore and trim
ram bore.
51148
b
c
a
a - Pivot Pin
b - Pivot Pin Bore
c - Trim Ram Bore
7. Using a suitable mallet, drive upper pivot pin into
swivel bracket and through trim ram until pivot pin
is flushed with swivel bracket.
51148
b
c
a
a - Pivot Pin
b - Swivel Bracket
c - Trim Ram
8. Drive upper dowel pin (RETAINED) into its re-
spective hole until seated.
51147
a
a - Dowel Pin
9. Remove trim fluid fill screw. Fluid level should be
to bottom of threads. Add Quicksilver Power Trim
and Steering Fluid (92-90100A12) or Automatic
Transmission Fluid (ATF) Type F, FA or Dexron II
to trim system, if necessary.
10. Reinstall fill screw.
11. Power trim may now be operated to lower out-
board to desired position. Trim system is self
bleeding.
12. Reconnect spark plug leads to spark plugs.
13. Reinstall top cowl.
14. Connect battery leads to battery terminals.
To Next Page
Loading...
