MID-SECTION - 5D-2790-817643R1 DECEMBER 1996
4. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
51147
a - Lower Cross Pin
5. Using a suitable punch, drive lower pivot pin into
clamp bracket and trim cylinder assembly until
pivot pin is flush with outside surface.
51148
a - Lower Dowel Pin
6. Apply Special Lubricant (92-13872A1) to surface
of upper pivot pin, pivot pin bore and trim ram
bore.
NOTE: Install trim ram with cross hole located as
shown. If trim ram is installed reversed, the trim send-
er (if installed) will not operate.
51515
a
b
b
c
Transom Side
Cross Hole
Engine Side
d
a - Pivot Pin
b - Pivot Pin Bore
c - Trim Ram Bore
d - Install Trim Ram As Shown
To Next Page
Loading...
