LOWER UNIT - 6A-990-817643R1 DECEMBER 1996
4. Replace reverse gear if gear teeth or clutch teeth on re-
verse gear are chipped or worn. If reverse gear must
be replaced, pinion and sliding clutch should also be in-
spected for damage.
5. If reverse gear bearing is rusted or does not roll freely,
replace bearing. Remove bearing and reverse gear
using bearing puller (91-27780).
51205
6. Remove ball bearing (a) from reverse gear (b) using
Universal Puller Plate (c) and mandrel (d).
51269
51289
a
b
c
d
a - Ball Bearing
b - Reverse Gear
c - Universal Puller Plate (91-37241)
d - Driver Head (91-37312)
7. If bearing (c) is rusted or does not roll freely, replace
bearing. Remove bearing and oil seals. Discard oil
seals.
51264
a
b
c
d
a - Driver Rod (91-37323)
b - Driver Head (91-37312)
c - Propeller Shaft Needle Bearing
d - Oil Seals (2)
8. Remove seals (if not removed with bearing) and O-ring
(a).
51263
a
To Next Page
Loading...
