LOWER UNIT - 6A-2390-817643R1 DECEMBER 1996
7. If removed previously, re-install seal (a) and plate (b).
51268
a
b
8. Install gasket (a) and face plate (b).
51293
a
b
IMPORTANT: If the old impeller is re-used, install in the
original (clockwise) direction of rotation.
9. Install drive key (a) and impeller (b).
51292
a
b
10. Lubricate I.D. of cover with Quicksilver Needle Bearing
Assembly Lubricant (P/N 92-42649A1). Install gasket
(a) with bead (b) towards cover.
51290
a
b
11. Rotate driveshaft clockwise and push cover down. Se-
cure cover.
51275
a
b
b
b
c
c
c
c
d
d
d
d
a - Cover
b - Isolators, (Design 1) Note: 2 isolators for forward screws are
different from remaining 4 isolators
c - Washers (6)
d - Bolts (6); Apply Loctite on threads and torque to 60 lb. in.
(6.8 N·m).
NOTE: Torque cover screws as shown.
51271
1
2
3
4
5
6
To Next Page
Loading...
