7B-16 - OUTBOARD INSTALLATION/ATTACHMENTS 90-817643R1 DECEMBER 1996
11. Slide brass barrel over throttle cable tube. Secure bar-
rel to tube with allen screw approximately 3.5 in. (89
mm) from stainless conduit. DO NOT OVERTIGHTEN
screw as tubing may be crushed binding throttle cable.
Position barrel to face towards tiller handle.
51607
b
c
d
a
a - Brass Barrel
b - Tube
c - Allen Screw
d - Tiller Handle
12. Install throttle cable guide onto throttle cable. Secure
guide to cable with anchor and two screws. Guide hole
should face up.
51602
b
c
a
a - Cable Guide
b - Screws (2)
c - Hole (Faces Up)
13. Position throttle arm slot to face stop harness exit hole
in tiller handle. Route stop switch harness through twist
grip, into throttle arm, and out through side of tiller han-
dle.
51602
b
c
d
e
a
a - Slot
b - Exit Hole
c - Harness
d - Twist Grip
e - Stop Switch
14. Secure twist grip to throttle arm with attaching screw.
51603
a
a - Screw
To Next Page
Loading...
