EasyManua.ls Logo

MICRO-EPSILON ILD1700-2 - Liability for Material Defects; Service, Repair; Decommissioning, Disposal

MICRO-EPSILON ILD1700-2
112 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 103
Liability for Material Defects
optoNCDT 1700
12. Liability for Material Defects
All components of the device have been checked and tested for functionality at the factory. However, if de-
fects occur despite our careful quality control, MICRO-EPSILON or your dealer must be notified immediately.
The liability for material defects is 12 months from delivery. Within this period, defective parts, except for
wearing parts, will be repaired or replaced free of charge, if the device is returned to MICRO-EPSILON with
shipping costs prepaid. Any damage that is caused by improper handling, the use of force or by repairs or
modifications by third parties is not covered by the liability for material defects. Repairs are carried out exclu-
sively by MICRO-EPSILON.
Further claims can not be made. Claims arising from the purchase contract remain unaffected. In particular,
MICRO-EPSILON shall not be liable for any consequential, special, indirect or incidental damage. In the inter-
est of further development, MICRO-EPSILON reserves the right to make design changes without notification.
For translations into other languages, the German version shall prevail.
13. Service, Repair
If the sensor or sensor cable is defective:
- If possible, save the current sensor settings in a parameter
set, see ILD1700 Tool, Measurement / Configuration menu,
to reload them into the sensor after the repair.
- Please send us the affected parts for repair or exchange.
If the cause of a fault cannot be clearly identified, please send
the entire measuring system to:
MICRO-EPSILON Optronic GmbH
Lessingstr. 14
01465 Langebrück / Germany
Tel. +49 (0) 35201 / 729-0
Fax +49 (0) 35201 / 729-90
optronic@micro-epsilon.com
www.micro-epsilon.com
14. Decommissioning, Disposal
Remove the power supply cable and output cable from the sensor.
Incorrect disposal may cause harm to the environment.
Dispose of the device, its components and accessories, as well as the packaging materials in compli-
ance with the applicable country-specific waste treatment and disposal regulations of the region of use.

Table of Contents