Page 7
Safety
optoNCDT 1700
1. Safety
The handling of the sensor assumes knowledge of the instruction manual.
1.1 Symbols Used
The following symbols are used in this instruction manual:
WARNING! - potentially dangerous situation
IMPORTANT! - useful tips and information
1.2 Warnings
Avoid unnecessary laser radiation to be exposed to the human body
- Switch off the sensor for cleaning and maintenance.
- Switch off the sensor for system maintenance and repair if the sensor is integrated into a system.
Caution - use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure.
Connect the power supply and the display/output device in accordance with the safety regulations for electri-
cal equipment.
> Risk of injury
> Damage to or destruction of the sensor
Avoid shocks and impacts to the sensor.
> Damage to or destruction of the sensor
Mount the sensor only to the existing holes on a flat surface. Clamps of any kind are not permitted.
> Damage to or destruction of the sensor
To Next Page
Loading...