Page 8
Safety
optoNCDT 1700
The power supply may not exceed the specified limits
> Damage to or destruction of the sensor
Avoid continuous exposure to spray on the sensor.
> Damage to or destruction of the sensor
Avoid exposure to aggressive materials (washing agent, penetrating liquids or similar) on the sensor.
> Damage to or destruction of the sensor
1.3 Notes on CE Marking
The following apply to the optoNCDT 1700:
- EU directive 2014/30/EU
- EU directive 2011/65/EU, “RoHS” category 9
Products which carry the CE mark satisfy the requirements of the EU directives cited and the European
harmonized standards (EN) listed therein. The EU Declaration of Conformity is available to the responsible
authorities according to EU Directive, article 10, at:
MICRO-OPTRONIC MESSTECHNIK GmbH
Lessingstr. 14
01465 Langebrück / Germany
The measuring system is designed for use in industrial environments and meets the requirements.
1.4 Proper Use
- The optoNCDT 1700 is designed for use in industrial applications. It is used
for measuring displacement, distance, position and elongation
for in-process quality control and dimensional testing
- The sensor must only be operated within the limits specified in the technical data, see Chap. 3.4.
- The sensor must be used in such a way that no persons are endangered or machines and other material
goods are damaged in the event of malfunction or total failure of the sensor.
- Take additional precautions for safety and damage prevention in case of safety-related applications.
To Next Page
Loading...