MICRO-EPSILON ILD1700-2

To Previous Page

MICRO-EPSILON MESSTECHNIK GmbH & Co. KG

Koenigbacher Str. 15 · 94496 Ortenburg / Germany

Tel. +49 (0) 8542 / 168-0 · Fax +49 (0) 8542 / 168-90

info@micro-epsilon.com · www.micro-epsilon.com

*X9751139-D10*

X9751139-D111129SWE

MICRO-EPSILON MESSTECHNIK

Main Page

Table of Contents3
Safety7
Symbols Used7
Warnings7
Notes on CE Marking8
Proper Use8
Proper Environment9
Laser Class10
Functional Principle, Technical Data12
Functional Principle12
Diffuse Reflection12
Direct Reflection13
Real Time Control13
Exposure Control14
Technical Data14
Control and Indicator Elements19
Delivery20
Scope of Delivery20
Storage20
Installation21
Sensor Mounting Diffuse Reflection22
Sensor Mounting Direct Reflection29
Connector and Sensor Cable32
Switching Inputs Laser On/Off, Setting Masters and the MID-Point33
Operation34
Getting Ready for Operation34
Membrane Keys35
LED-Functions36
Inputs and Outputs36
Menu, Setting the Parameters37
Average Setting39
Averaging Number N39
Moving Average (Default Setting)40
Recursive Average41
Median41
Setting Masters42
Setting MID-Point44
Frequency and Output Rate46
Operation Mode47
Error Mode (Error Control)47
Switch Mode47
Output Circuit for the Switching Outputs49
Synchronization of Sensors49
Exposure Time50
Timing, Measurement Value Flux51
Triggering53
Basics53
Trigger Modes53
Trigger Signal Levels54
Trigger Pulse54
Pin Assignment for External Trigger Signal55
Measurement Value Output56
Voltage Output56
Current Output57
Digital Value Output57
Digital Error Modes58
Serial Interface RS42259
Interface Parameters60
Data Format for Measurement Values and Error Codes60
Binary Format60
ASCII Format61
Set-Up of the Commands62
Command Reply63
Communication Without Error63
Communication with Error64
Commands65
Overview65
Reading out the Sensor Parameters67
Reading out the Sensor Settings68
Set Average Number72
Set Average Type75
Starting and Stopping the Measurement Value Output76
Set Limit Values77
Assignment of the Limits to the Switch Outputs78
Operation Mode79
Set the Measurement Value Output Type80
Set Measurement Frequency (Speed)80
Error Output (Analog Output)82
Synchronous and Trigger Mode83
Switching off the Laser (External)84
Switching the Data Format85
Key Lock86
Set Factory Setting86
Reset Sensor87
Reading out the Measurements88
Enable / Lock the Flash for Setting Masters and the MID-Point89
Mastering or Setting MID-Point90
Instruction for Operating92
Reflection Factor of the Target Surface92
Error Influences93
Light from Other Sources93
Color Differences93
Temperature Influences93
Mechanical Vibration93
Movement Blurs93
Surface Roughness94
Sensor Tilting95
Optimizing the Measuring Accuracy96
Protective Housing97
ILD1700 Tool100
Installation and Preparation for Measurements100
System Requirements100
Cable and Program Routine Requirements100
Measurement101
Software Support with Medaqlib102
Liability for Material Defects103
Service, Repair103
Decommissioning, Disposal103
Appendix A 1 Accessory104
A 2 Factory Setting105
A 3 Output Rate Optoncdt1700106
A 4 Pin Assignment Sensor Cable107
Pin Assignment RS422 Connection109
A 6 Pin Assignment PC1700-X/X/Usb/Oe/Ind110

MICRO-EPSILON ILD1700-2 - Page 112

Table of Contents