Microhard Systems IPN3G - Page 146

© Microhard Systems Inc. 146
5.0 AT Commands
AT+MUDMTC
Command Syntax
Set USB data port modbus tcp configuration
AT+MUDMTC=<Status>, <Protection
Status>, <Protection Key>
Status and Protection Status:
0 - Disable
1 - Enable
Description
Example
Input:
AT+MUDMTC=0,0,1234<enter>
Response:
OK
AT+MUDIPM
Command Syntax
Set the USB data port IP protocol mode.
AT+MUDIPM=<mode>
0 - TCP Client
1 - TCP Server
2 - TCP Client/Server
3 - UDP Point to Point
4 - UDP Point to Multipoint (P)
5 - UDP Point to Multipoint (MP)
6 - UDP Multipoint to Multipoint
Description
Example
Input:
AT+MUDIPM=5<enter>
Response:
OK
AT+MUDTC
Command Syntax
Set USB data port TCP Client configuration,
when set to TCP Client mode.
AT+MUDTC=<Remote Server IP>,
<Remote Server Port>, <Outgoing
Connection Timeout>
Description
Example
Input:
AT+MUDTC=192.168.0.189,20001,60 <enter>
Response:
OK
The AT&W command
must be issued to save
changes!