Microhard Systems IPN3G - Page 148

© Microhard Systems Inc. 148
5.0 AT Commands
AT+MUDUPP
Command Syntax
Set USB data port UDP point to point
configuration when configured in UDP point to
point mode.
AT+MUDUPP=<Remote Server IP>,
<Remote Server Port>, <Local Listening
Port>, <UDP timeout_s>
Description
Example
Input: (Entering Values)
AT+MUDUPP=0.0.0.0,20003,20003,10<enter>
Response:
OK
Input: (Retrieving Values)
AT+MUDUPP?<enter>
Response:
+MUDUPP: Remote IP Address:0.0.0.0,Remote Port:20003,Listening Port:20003,UDP Ti
meout(s):10
OK
AT+MUDUPMP
Command Syntax
Set the USB data port UDP point to multipoint
as point configuration when IP protocol is set to
UDP point to multipoint (P)
AT+MUDUPMP=<Multicast IP>, <Multicast
Port>, <Listener Port>, <Time to live>
Description
Example
Input: (Entering Values)
AT+MUDUPMP=224.1.1.3,20003,20013,1 <enter>
Response:
OK
Input: (Retriieving Values)
AT+MUDUPMP?<enter>
Response:
+MUDUPMP: Multicast IP Address:224.1.1.3,Multicast Port:20003,Listening Port:200
13,Time to Live:1
OK
The AT&W command
must be issued to save
changes!