Microhard Systems IPN3G - Page 149

© Microhard Systems Inc. 149
5.0 AT Commands
AT+MUDUPMM
Command Syntax
Set the USB data port UDP point to multipoint
as MP configuration when IP protocol is set to
UDP point to multipoint (MP)
AT+MUDUPMM=<Remote IP>, <Remote
Port>, <Multicast IP>, <Multicast Port>
Description
Example
Input: (Entering Values)
AT+MUDUPMM=0.0.0.0,20003,224.1.1.3,20003<enter>
Response:
OK
Input: (Retrieving Values)
AT+MUDUPMM?<enter>
Response:
+MUDUPMM: Remote IP Address:0.0.0.0,Remote Port:20013,Multicast IP Address:224.1
.1.3,Multicast Port:20003
OK
AT+MUDUMPMP
Command Syntax
Set the USB data port UDP multipoint to
multipoint configuration when IP protocol is set
to UDP multipoint to multipoint.
AT+MUDUMPMP=<Multicast IP>,
<Multicast Port>, <Time to live>, <Listen
Multicast IP>, <Listen Multicast Port>
Description
Example
Input: (Entering Values)
AT+MUDUMPMP=224.1.1.3,20013,1,224.1.1.3,20013 <enter>
Response:
OK
Input: (Retriieving Values)
AT+MUDUMPMP?<enter>
Response:
+MUDUMPMP: Multicast IP Address:224.1.1.3,Multicast Port:20013,Time to Live:1,Li
sten Multicast IP Address:224.1.1.3,Listen Multicast Port:20013
OK
The AT&W command
must be issued to save
changes!