Microhard Systems IPN3G - Page 152

© Microhard Systems Inc. 152
5.0 AT Commands
AT+MDOD
Command Syntax
Enable/Disable Dial-on-Demand. If disabled,
the modem will always remain connected. The
default is Disabled.
AT+MDOD=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MDOD=0<enter>
Response:
OK
AT+MPITO
Command Syntax
The maximum amount of time to pass before
modem will timeout. The default is 0 seconds.
AT+MPITO=<Value>
0 - 65535 seconds
Description
Example
Input:
AT+MPITO=0 <enter>
Response:
OK
AT+MPCTO
Command Syntax
The maximum amount of time to wait for a
connection The default is 90 seconds.
AT+MPCTO=<Value>
0 - 65535 seconds
Description
Example
Input:
AT+MPCTO=90<enter>
Response:
OK
The AT&W command
must be issued to save
changes!