Microhard Systems IPN3G - Page 161

© Microhard Systems Inc. 161
5.0 AT Commands
AT+MCOP
Command Syntax
Set COM1 port priority.
AT+MCOP=<Mode>
Mode:
0 Normal
1 Medium
2 High
Description
Example
Input:
AT+MCOP=0<enter>
Response:
OK
AT+MCONCDI
Command Syntax
Enable/Disable no-connection data intake.
AT+MCONCDI=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MCONCDI=0 <enter>
Response:
OK
AT+MCOMTC
Command Syntax
Set COM1 modbus TCP configuration
AT+MCOMTC=<Status>, <Protection
status>, <Protection Key>
Status and Protection Status:
0 Disable
1 Enable
Description
Example
Input:
AT+MCOMTC=0,0,1234<enter>
Response:
OK
The AT&W command
must be issued to save
changes!