Microhard Systems IPN3G - Page 163

© Microhard Systems Inc. 163
5.0 AT Commands
AT+MCOTCS
Command Syntax
Set COM1 TCP Client/Server parameters when
configured as TCP Client/Server mode.
AT+MCOTCS=<Remote Server IP>,
<Remote Server Port>, <Outgoning
timeout_s>, <Polling Mode>, <Polling
timeout_s>, <Local Listener Port>,
<Connection timeout_s>
Polling Mode:
0 Monitor
1 Multi-polling
Description
Example
Input:
AT+MCOTCS=0.0.0.0,20001,60,0,100,20001,300<enter>
Response:
OK
AT+MCOUPP
Command Syntax
Set COM1 UDP Point-to-Point configuration
when set to UDP Point-to-Point mode.
AT+MCOUPP=<Remote Server IP>,
<Remote Server Port>, <Liste
ner Port>, <UDP timeout_s>
Description
Example
Input:
AT+MCOUPP=0.0.0.0,20001,20001,10<enter>
Response:
OK
AT+MCOUPMP
Command Syntax
Set COM1 UDP Point-to-Multipoint as point
parameters when configured in UDP Point-to-
Multipoint (P) mode.
AT+MCOUPMP=<Multicast IP>, <Multicast
Port>, <Listener Port>, <Time to live>
Description
Example
Input:
AT+MCOUPMP=224.1.1.1, 20001, 20001, 1 <enter>
Response:
OK
The AT&W command
must be issued to save
changes!