Microhard Systems IPN3G - Page 164

© Microhard Systems Inc. 164
5.0 AT Commands
AT+MCOUPMM
Command Syntax
Set COM1 UDP Point-to-Multipoint as MP
parameters when configured in UDP Point-to-
Multipoint (MP) mode.
AT+MCOUPMM=<Remote IP>, <Remote
Port>, <Multicast IP>, <Multicast Port>
Description
Example
Input:
AT+MCOUPMM=0.0.0.0,20001,224.1.1.1,20001<enter>
Response:
OK
AT+MCOUMPMP
Command Syntax
Set COM1 UDP Multipoint-to-Multipoint
parameters when set to UDP Multipoint-to-
Multipoint mode.
AT+MCOUMPMP=<Multicast IP>,
<Multicast Port>, <Time to live>, <Listen
Multicast IP>, <Listen Multicast Port>
Description
Example
Input:
AT+MCOUMPMP=224.1.1.1,20011,1,224.1.1.1,20011<enter>
Response:
OK
AT+MCOSMTP
Command Syntax
Set COM1 SMTP Client Configuration when
set to SMTP Client mode.
AT+MCOSMTP=<Mail Subject>, <Mail
Server>, <Mail Recipient>, <Message Max
Size>, <Timeout_s>, <Transfer Mode>
Transfer Mode:
0 Text
1 Attached File
2 Hex Code
Description
Example
Input:
AT+MCOSMTP=COM1 Message, mail.mymail.com, host@email.com, 1024, 10, 0<enter>
Response:
OK
The AT&W command
must be issued to save
changes!