Microhard Systems IPN3G - Page 165

© Microhard Systems Inc. 165
5.0 AT Commands
AT+MCOPPP
Command Syntax
Set COM1 PPP parameters when COM1 is
configured in PPP Mode.
AT+MCOPPP=<PPP Local IP>, <PPP Host
IP>, <PPP idle timeout_s>
Description
Example
Input:
AT+MCOPPP=192.168.0.1,192.168.0.99,30<enter>
Response:
OK
AT+MCTPS
Command Syntax
Enable/Disable the COM2 serial port. This port
is located on the front of the IPn3G and is
labelled as the DIAGNOSTIC port.
AT+MCTPS=<Mode>
Mode:
0 Disable
1 Enable
Description
Example
Input:
AT+MCTPS=0<enter>
Response:
OK
AT+MCTBR
Command Syntax
Set COM2 baud rate.
AT+MCTBR=<Baud Rate>
Baud Rate:
0 300
1 600
2 1200
3 2400
4 3600
5 4800
6 7200
7 9600
8 14400
9 19200
10 28800
11 38400
12 57600
13 115200
Description
Example
Input:
AT+MCTBR=13<enter>
Response:
OK
The AT&W command
must be issued to save
changes!