© Microhard Systems Inc. 214
Appendix H: “system.conf” File Structure (18 of 25)
#Interval(s):
Event_Timer0=0
#Interval(s):
Event_Timer1=0
#Interval(s):
Event_Timer2=0
#Interval(s):
Event_Timer3=0
#Message#1: A - None B - Modem Info C - Carrier Info
# D - WAN Info
Event_Message_type0=AAAA
#Message#2:
Event_Message_type1=AAAA
#Message#3:
Event_Message_type2=AAAA
#GRE Tunnel Name:
GRE_Tunnel_Name=gre
#GRE Tunnel Local Status: A - Disable B - Enable
GRE_Tunnel_Local_Status=B
#GRE Tunnel Remote Status: A - None B - Dead C - Alive
GRE_Tunnel_Remote_Status=A
#Multicast: A - Disable B - Enable
GRE_Tunnel_Multicase=B
#ARP: A - Disable B - Enable
GRE_Tunnel_ARP=B
GRE_Tunnel_TTL=255
#Keep Alive Check: A - Disable B - Enable
GRE_Tunnel_DPD=A
#Peer IP Address:
GRE_Tunnel_DPD_IP=0.0.0.0
#Delay(s):
GRE_Tunnel_DPD_Delay=30
#Timeout(s):
GRE_Tunnel_DPD_Timeout=120
#Action: A - Hold_Tunnel B - Disable_Tunnel C - Delete_Tunnel
GRE_Tunnel_DPD_Action=A
#Local GRE Tunnel IP ddress:
GRE_Tunnel_Local_IP=0.0.0.0
#Net Mask:
GRE_Tunnel_Local_Netmask=0.0.0.0
#Local WAN IP Address:
GRE_Tunnel_Local_WAN_IP=0.0.0.0
#Subnet IP Address:
GRE_Tunnel_Remote_SubIP=0.0.0.0
To Next Page
Loading...
