Microhard Systems IPN3G - Page 59

© Microhard Systems Inc. 59
4.0 WebUI Configuration
Protocol Config (continued)
SMTP Client: If the IPn3G network has Internet access, this protocol may be used to send the data
received on the serial port (COM1), in a selectable format (see Transfer Mode (below)), to an e-mail
addressee. Both the SMTP Server and the e-mail addressee must be ‘reachable’ for his feature to
function. Note: COM2 does not support this mode.
 Mail Subject
Enter a suitable ‘e-mail subject’ (e-mail heading).
Default: COM1 Message
 Mail Server (IP/Name)
IP address or ‘Name’ of SMTP (Mail) Server.
Default: 0.0.0.0
 Username / Password
The username/password of the email account being used, if authentication is required for
outgoing email.
Default: varies/varies
 Mail Recipient
A valid e-mail address for the intended addressee, entered in the proper format.
Default: host@
 Message Max Size
Maximum size for the e-mail message.
Default: 1024
 Timeout (s)
How long the unit will wait to gather data from the serial port before sending an e-mail
message; data will be sent immediately upon reaching Message Max Size.
Default: 10
 Transfer Mode
Select how the data received on COM1 is to be sent to the email addressee. Options are:
Text, Attached File, Hex Code.
Default: Text
PPP: COM1 can be configured as a PPP server for a serial connection with a PC or other device. The
attached PC could then use a dedicated serial (WindowsXP - dialup/modem) type PPP connection to
access the network resources of the IPn3G. Note: COM2 does not support this mode.
 PPP Local IP
Enter the local PPP IP Address, the IP Address of the IPn3G COM1 Port.
Default: 192.168.0.1
 PPP Host IP
Enter the PPP Host IP here. This is the IP of the PC or attached device.
Default: 192.168.0.99
 PPP Idle Timeout(s)
Enter the desired PPP Idle Timeout in seconds.
Default: 30
SMTP: Simple Mail
Transport Protocol is a
protocol used to transfer
mail across an IP
network.