Installing the Software TriStar II 3020
4-6 302-42828-01 - Dec 2012
a.) In the Step 2 group box, enter the serial number for each analyzer to be attached to this
computer. The analyzer’s serial number label is located near the power switch.
b.) Click Next
.
9. On the Ethernet Ports screen, select one option from the following table:
If... Then...
the configured port is listed Select the port then click Next to proceed to the next step.
the configured port is not
listed
Click Specify.
On the Specify Ethernet Port screen, enter the remaining portion of
the IP address in the enabled fields then click Next.
To Next Page
Loading...
