Microplex LOGIJET T4 - RFID Panel Functions; Selecting the RFID Mode

Using the RFID Functions 111
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
8.2. RFID Panel Functions
8.2.1. Selecting the RFID Mode
With this panel function the RFID mode can be enabled or disabled.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[RFID Menu ]
[RFID Mode ]
[OFF ]
& & &
[ON ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key
until [RFID Menu ] is displayed.
Press the NEXT or PREVIOUS key until
the desired value is displayed.
The RFID mode is selected.
In addition this new value can be
saved as setup value (using the ENTER
key).
After this decision turn the printer ON
LINE again: Press the ENTER key
longer than 2 seconds.