60 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.3. Page Length Adjustment
Hint:
After inserting new material (e.g. paper) this function is used to adjust the printer to
the new page length.
Alternatively, the printer itself is able to measure the label length. See next sections.
OFFL.
MENU
NEXT
ENTER
ENTER
ENTER
NEXT
ENTER
NEXT
ENTER
ESC
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Paper Menu ]
[Paper Size ]
[Page Length ]
[Measure Length ]
& & &
[in mm ]
& & &
[Digit4 149.9]
& & &
[Digit1 149.5]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to the
menu structure.
Press the NEXT or PREVIOUS key until [Paper
Menu ] is displayed.
Press the ENTER key to select the paper menu.
Press the ENTER key to select the paper size
menu.
Press the ENTER key to adjust the page length.
Press the NEXT or PREVIOUS key if you want to
adjust the page length manually:
mm = currently selected measuring unit.
(Alternative the units inch or dot can be chosen
with NEXT or PREVIOUS).
Pressing the VAL+ or VAL- key changes the
value of the current digit (Digit4 = left position,
in this example: 1). Pressing the NEXT key
moves you to the next digit (the PREVIOUS key
combination moves you back, if need be).
The page length is changed to 149.5 mm.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON LINE
again: Press the ENTER key longer than 2
seconds.
To Next Page
Loading...