Microplex LOGIJET T4 - Configuration of Text Margins

Panel Functions 63
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.5. Configuration of Text Margins
This function sets text margins. Margins are expressed in dots at
the concerning edge of the paper.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Page Menu ]
[Font Number ]
& & &
[Margin ]
[Left ]
& & &
[from Right ]
[Digit4 0081]
& & &
[Digit1 0087]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Page Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Margin ] is displayed.
Press the NEXT or PREVIOUS key until the
desired margin is displayed.
Pressing the VAL+ or VAL- key changes the
value of the current digit (Digit4 = left
position, in this example: 0). Pressing the
NEXT key moves you to the next digit (the
PREVIOUS key combination moves you
back, if need be).
The right margin is changed into 87 dot.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ENTER key longer
than 2 seconds.