Microplex LOGIJET T4 - Selecting the Communication Protocol

112 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
8.2.2. Selecting the Communication Protocol
With this panel function the protocol for communication between RF
Write/Read module and transponder is selected (matching to the RFID label
type in use).
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[RFID Menu ]
[RFID Mode ]
& & &
[Protocol ]
[Gen 2 ]
& & &
[ISO18000-6b ]
[Saved ! ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[RFID Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Protocol ] is displayed.
Press the NEXT or PREVIOUS key until the
desired value is displayed.
The protocol ISO18000-6b is selected
(saved as setup value).
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.