Using the RFID Functions 123
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
8.4. IDOL Commands for RFID
Your MICROPELX RFID printer has been engineered to read and to program
RFID (Radio Frequency Identification) labels (commonly called "RFID tags").
The commands for the RFID functions are sent like print data via the active
data channel (Centronics, USB, Ethernet,...).
The RFID capabilities enable you to read the ID (Transponder identification
number) of RFID labels, for example, and to transmit it to the host via the
printer's status channel.
The user may add personalized ID data (a page identification number, e.g.)
to send it to the host, too.
This allows a clearly assignment of a specific label identification number to
the information printed on this label.
Note: If the RFID tag is not readable/programmable for any reason, the label will
be printed with an overstrike pattern, indicating that it should not be used.
(Compare section 8.2.4 Adjusting the Number of RFID Access and section
8.6 RFID Errors).
8.4.1. Overview Function Group RFID
Function: Thanks to a number of parameters the rf command can be used
for many different RFID tasks.
Syntax: <ESC><ESC>rf <k
xx
nn> ... <k
99
"cc">
To Next Page
Loading...