Microplex LOGIJET T4 - Selecting the Print Mode

102 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.31. Selecting the Print Mode
With this function the procedure for the label output and print is defined.
The different print modes are described on the following pages.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[TearOff Menu ]
[TearOff Mode ]
& & &
[Print Mode ]
[Real 1:1 Mode ]
& & &
[Normal 1:1 Mode ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key
until [TearOff Menu ] is displayed.
Press the NEXT or PREVIOUS key
until [Print Mode ] is displayed.
The currently set print mode is
displayed.
Press the NEXT or PREVIOUS key until
the desired print mode is displayed.
The Normal 1:1 mode is selected.
In addition this new value can be
saved as setup value (using the ENTER
key).
After this decision turn the printer ON
LINE again: Press the ENTER key
longer than 2 seconds.