Microplex LOGIJET T4 - Setting to Factory Default

78 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.18. Setting to Factory Default
This function back-outs all configurations to factory defaults.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Configuration ]
[Interface ]
& & &
[Factory Default ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the NEXT or PREVIOUS key until
[Factory Default ] is displayed.
Only if you press the ENTER key a
second time the configuration will be
back-outed to factory defaults.
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.