Microplex LOGIJET T4 - Media Setting (Material; Label or Continuous)

Panel Functions 59
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.2. Media Setting (Material; Label or Continuous)
This function allows to adjust the printer to the actual used material
(distinction between formatted media (label) and continuous media).
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Paper Menu ]
[Paper Size ]
& & &
[Material ]
[Label ]
& & &
[Continuous ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Paper Menu] is displayed.
Press the NEXT or PREVIOUS key
until [Material ] is displayed.
Select sub-menu Material.
Press the NEXT or PREVIOUS key
until the statement shown by the
display corresponds to the inserted
media (Continuous e.g.).
The printer is adjusted to continuous
material.
In addition this new value can be
saved as setup value (using the
ENTER key).
After this decision turn the printer
ON LINE again: Press the ENTER
key longer than 2 seconds.