Microplex LOGIJET T4 - Page 58

58 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[Process ]
[Thermo direct ]
& & &
[Thermo transfer ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Engine] is displayed.
The menu item Engine is selected.
Press the NEXT or PREVIOUS key
until [Process] is displayed.
The menu item Process is selected.
Press the NEXT or PREVIOUS key
until the display message is
corresponding with the printer
implementation (ribbon inserted =
Thermo transfer e.g.).
The thermal transfer print process is
selected.
In addition this new value can be
saved as setup value (using the
ENTER key).
After this decision turn the printer
ON LINE again: Press the ENTER
key longer than 2 seconds.