Microplex LOGIJET T4 - Printing the Font List

66 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.7. Printing the Font List
This function generates a list of all fonts installed to the printer.
The font list shows demo prints of all fonts and, in addition, the
concerning PCL selection commands. These commands contain
information on font width and font height (see section 7.19
Font Selection, too).
OFFL.
MENU
ENTER
NEXT
ENTER
ENTER
Panel display
[[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
[Status Sheet ]
& & &
[Font List ]
[Font List ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Menu Level 1 is selected.
Press the NEXT or PREVIOUS key
until [Font List ] is displayed.
The font list is printed.
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.