Microplex LOGIJET T4 - Normal Print Mode Activation (incl. FORM FEED)

68 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.9. Normal Print Mode Activation (incl. FORM FEED)
The normal print mode suspends the Hexdump-Mode.
This function is activated, when a print job must be continued
without turning the printer off and on again.
In addition to that the function “Normal Print Mode Activation“ is
used to produce a FORM FEED.
OFFL.
MENU
ENTER
NEXT
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
[Status Sheet ]
& & &
[Normal Print/FF ]
[Normal Print/FF ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key
until [Normal Print/FF ] is displayed.
The normal print mode is activated.
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.
Note:
After activating the normal print mode a FORM FEED is released
automatically and one sheet is put out.
This is necessary because after a test in the Hexdump Mode it is
possible that data can remain in the input buffer unintentionally
(cause: in the Hexdump Mode no control characters are evaluated
and no FORM FEED is effected).