Microplex LOGIJET T4 - Emulation Selection

Panel Functions 73
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.14. Emulation Selection
With this function you can change the active emulation.
OFFL.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Configuration ]
[Interface ]
& & &
[Emulation ]
[SOLID Standard ]
& & &
[HP PCL 5 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
Press the NEXT or PREVIOUS key until
[Emulation ] is displayed.
Press the NEXT or PREVIOUS key until
the desired emulation (e.g. HP PCL 5)
is displayed.
The emulation HP PCL 5 is selected.
In addition this new value can be
saved as setup value (using the ENTER
key).
After this decision turn the printer ON
LINE again: Press the ENTER key
longer than 2 seconds.