168 Appendix
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
13.2. Survey of Print Job Status Messages
1000 : One page was printed well.
This message will appear after each page of a print job, if the
status channel is set to automatical mode.
1010 : Power on - state.
This message will appear after turning on the printer. Now the
printer will be warmed up and ready for printing. All settings will
be switched to the EEPROM values.
1011 : IDLE - state.
This is not an automatical message. This message will be sent only
after a request ( <ESC><ESC>: 0011).
Idle means:
- No more pages are in the print process (job is finished).
- All pages left the printer.
- No print data (without FF) are present.
1012 : BUSY - state.
Job is still in the printing process.
This is not an automatical message. This message will be sent only
after a request ( <ESC><ESC>: 0011).
1020 : Answer to a RFID support command.
This message will appear after a command like "Read Label ID
Number" was sent to the printer.
To Next Page
Loading...