Microplex LOGIJET T4 - Reading the Label Identification Number automatically

Using the RFID Functions 121
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
8.2.6. Reading the Label Identification Number automatically
This function enables to read the transponder identification number (ID) of RFID labels
during the print process and send it to the host automatically (Status message: page
handshake incl. ID). Compare IDOL commands in section 8.4.2 and 8.4.4.
In addition this function helps to find the optimal tag position (see section 8.2.3) by
reading the label automatically and showing the reading results on the panel display.
OFFL
.
MENU
NEXT
ENTER
NEXT
ENTER
NEXT
ENTER
N
E
XT
ENTER
ESC ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Engine ]
[Printspeed ]
& & &
[RFID Menu ]
[RFID Mode ]
& & &
[Autom. Read ID ]
[OFF ]
& & &
[ON ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to the
menu structure.
Press the NEXT or PREVIOUS key until
[Engine ] is displayed.
Press the NEXT or PREVIOUS key until
[RFID Menu ] is displayed.
Press the NEXT or PREVIOUS key until
[Autom. Read ID ] is displayed.
Press the NEXT or PREVIOUS key until the
desired value is displayed.
The automatic label ID reading function is
selected.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON LINE
again: Press the ENTER key longer than 2
seconds.