72 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.13. Data Interface Configuration
This function is used to set the interface parameters.
OFFL.
MENU
NEXT
ENTER
ENTER
ENTER
NEXT
ENTER
ESC
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
& & &
[Configuration ]
[Interface ]
[Timeout ]
[Digit3 030 ]
& & &
[Digit2 04
0 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
The MENU key gives the user access to
the menu structure.
Press the NEXT or PREVIOUS key until
[Configuration ] is displayed.
The currently set value for he timeout is
displayed (here: 30 seconds).
Pressing the VAL+ or VAL- key changes the
value of the current digit (Digit3 = left
position, in this example: 0). Pressing the
NEXT key moves you to the next digit (the
PREVIOUS key combination moves you
back, if need be).
The timeout (the waiting period for SIA to
switch to the next interface) is increased
to 40 seconds.
In addition this new value can be saved as
setup value (using the ENTER key).
After this decision turn the printer ON
LINE again: Press the ENTER key longer
than 2 seconds.
Note:
The printer uses SIA (Simultaneous Interface Administration) to check,
which interface is currently used for the transfer of print data.
To Next Page
Loading...