Microplex LOGIJET T4 - Reduced Print Quality

152 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
10.2. Reduced Print Quality
Defect Remedies
Printout too light - check the print process selecting and correct it, if
necessary (see section 7.1)
- check the printhead pressure (see section 9.3
Adjusting the Right Pressure Value).
- check the ribbon transport (load the ribbon again,
if necessary; see section 5.3)
- increase the contrast (see section 7.23)
- choose different consumables (adjust media to
the ribbon resp. print process or vice versa, see
chapter 3, 5 and 7)
- check the environment conditions and correct them
if necessary (admissible values for humidity,
temperature etc., see chapter 2.3 and 12)
Printout too strong - check the print process selecting and correct it, if
necessary (see section 7.1)
- reduce the contrast (see section 7.23)