Microplex LOGIJET T4 - Page 153

Troubleshooting 153
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
Defect Remedies
Printout blurred or
incomplete
- clean the printhead
(see section 9.1.2)
- check the ribbon transport
(load the ribbon again, if necessary;
see section 5.3)
- also, see section 10.3: Incorrect Media Transport
- the printhead has to be exchanged if, for example
after a big printout performance the printout isn’t
correct any more (printhead exchange; see
section 9.2)
If the remedies above are not successful, please call a MICROPLEX
authorized service engineer.