Control Panel 51
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
6.5. Configuration via the Control Panel
You can use the control panel to change the printer configuration
and customize your printer to meet your specific needs.
In addition a software (called IP printADMIN
) will be available
for the LOGIJET T4 /T6 /RFID printers to allow a printer
configuration via Ethernet.
The controller has its integrated website with information on the
printer status and the printjob status.
Chapter 7 (Panel Functions) describes how to reach the particular
printer functions via the panel.
T e m p o r a r y changes in printer configuration are effective
only as long as the printer stays turned on. To select such
changes temporarily, the user must terminate the change of
function by pressing the ENTER key one single time.
P e r m a n e n t changes in printer configuration are active
each time the printer is turned on again. To select such changes
permanently, the user must terminate the change of function by
pressing the ENTER key two times.
An output of the current printer values can be generated using
the “Printing the Status Sheet“ panel function (see section 7.6).
To Next Page
Loading...