Microplex LOGIJET T4 - Generating Test Prints (Sliding Pattern)

Panel Functions 71
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.12. Generating Test Prints (Sliding Pattern)
This function generates a series of test prints without sending
data to the printer.
These test prints facilitate error analysis.
OFFL.
MENU
ENTER
NEXT
ENTER
ENTER
Panel display
[ON LINE ]
[OFF LINE ]
[Menu Level 1 ]
[Status Sheet ]
& & &
[Sliding Pattern ]
[Sliding Pattern ]
Notes
Turn the printer OFF LINE with this
key.
The MENU key gives the user access
to the menu structure.
Menu level 1 is selected.
Press the NEXT or PREVIOUS key
until [Sliding Pattern ] is displayed.
A series of test prints is generated.
Turn the printer ON LINE again:
Press the ENTER key longer than 2
seconds.
!
The printing out of test prints can be stopped by pushing the
ESC key.