Microplex LOGIJET T4 - Peripheral Device Activation (Tear Off Edge, Cutter)

98 Panel Functions
________________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
7.29. Peripheral Device Activation (Tear Off Edge, Cutter)
After installation or deinstallation of a peripheral device this function
has to be used to adjust the printer configuration.
Start the printer in the Service Mode:
FEED
+
PAUSE
Turn the printer on
Panel display
[Service Mode ]
Notes
Before starting the printer the
left panel key and the panel key in
the middle have to be pressed
simultaneously. (Inscription above
this keys: FEED and PAUSE.)
Turn the printer on and keep the two
keys pressed until the messages
[Service Mode ] is displayed
shortly.
Now the functions of the service
mode are available (compare
dashed areas in the Menu Structure
of section 6.6).